The main question addressed in this work is as follows: Under pure electrosorption conditions, that is, disregarding nonelectrostatic effects, how does the net adsorption of a polyelectrolyte at an oppositely charged surface respond to the addition of simple salt? Previous simulations and mean-field calculations have suggested that the polymers will desorb. However, we will demonstrate that an increased adsorption also is possible, even for pure electrosorption, at low and intermediate levels of salt. As this is a correlation-driven effect, mean field approaches will fail to capture it. Using simulations, one will in general need to simulate large systems and relatively long polymers. Also important is the presence of a proper bulk solution, with a finite and well-defined polyelectrolyte concentration. We have performed a theoretical study of polyelectrolyte adsorption, assuming screened Coulomb interactions between monomers; that is, the salt is implicit. This work focuses on the effects from ionic screening and polymer length. Specifically, the adsorption at a weakly charged colloidal particle, with a diameter of 200 nm, is monitored for various salt concentrations, in the presence of highly charged chains. Using simulations, we investigate polymers with two different degrees of polymerization: 40 and 160, respectively. These simulations are complemented by predictions from classical polymer density functional theory, utilizing a recently developed correlation-correction (Forsman, J.; Nordholm, S. Langmuir, in press). The agreement with corresponding simulations is semiquantitative, and because the calculations run many orders of magnitude faster than the simulations, longer and more realistic polymers could be studied with this approach. However, switching off the correlation-correction leads to a mean-field theory, which fails to even qualitatively reproduce the simulated response to screening.