Linear polymers are restricted to use in processes that involve severe extensional deformation, such as fiber spinning, film blowing, and thermoforming. To extend their applicability, the extensional properties of polymer melts should be enhanced such that strain hardening, which is defined as an increase in extensional viscosity under a large strain that deviates from the linear viscoelastic curve, is pronounced. In this study, a novel preparation method of linear polymer/inorganic nanocomposites was proposed with a main focus on enhanced melt strength. The design of molecular structure consists of three components-linear polymer, compatibilizer, and surface-modified particles. High-density polyethylene was used as a linear polymer while polyethylene grafted with maleic anhydride was used as a compatibilizer. Silica particles were synthesized and modified on their surfaces by 3-aminopropyltriethoxysilane. The strain hardening behavior of the surface-modified silica composites was pronounced. However, such a result was not observed for the composites of the same composition with pure-silica. In addition, the dispersion of the modified silica was much better than that of pure-silica.