For the experimental determination of adhesion strength between materials it is desirable to have a uniform stress distribution within the interface of the specimen. The common butt-test with a flat interface between two adhering materials produces stress singularities at the edges of the specimen but shows uniform stress distribution along the interface within the material. To avoid a premature failure at the edge due to the presence of the singular stress field, a notch can be machined at the interface within one of the materials. For isotropic materials, the notch geometry depends on the Dundurs parameters of the bimaterial system. This notch produces a certain local material angle and eliminates stress singularities at the specimen edges. Analytical and finite-element calculations provide the notch geometry appropriate for uniform stress distribution along the whole interface. The applicability of the test is proven by the determination of adhesion strength between polycarbonate and thermoplastic polyurethane. (C) Koninklijke Brill NV, Leiden, 2012