In the municipality of Sodertalje two large industries use much of the electricity, district heating (DH) and chilled water in the area. The Sodertalje energy system is not isolated, however, but is connected to the DH systems of southern and central Stockholm, and a change in the Sodertalje energy system will also influence the connected energy systems in Stockholm. The cooling demand in Sodertalje is currently covered by lake water cooling and compression chillers, but in order to reduce the use of electricity, conversion to absorption cooling or increased lake water cooling can be considered. The large combined heat and power (CHP) plant in Sodertalje is not used to its full potential today, but investment in absorption cooling and/or a cold condenser unit integrated with the CHP plant could increase the plant's operation hours. In this paper the system effects of introducing new industrial cooling supply in Sodertalje has been investigated through optimizations of a model including both the industries and the district heating supply in Sodertalje and Stockholm. The results show that, independently of whether condensing power production is feasible in the CHP plant or not, investments in both increased lake water cooling and absorption cooling are profitable. A sensitivity analysis of how energy market prices affect the results shows that even though the system cost will change depending on energy market prices, the optimum cooling technology mix will remain the same. However, a sensitivity analysis of the transfer DH capacity between the Sodertalje and Stockholm energy systems shows that if the transfer DH capacity is increased, absorption cooling will be less profitable since more heat can be sold from Sodertalje to Stockholm while at the same time reducing the use of fuel resources. (C) 2011 Elsevier Ltd. All rights reserved.