In this paper, waste sawdust was functionalized by monosodium glutamate for improving its cationic sorption capacity. The functionalized sawdust (FS) and crude sawdust (CS) were compared for their malachite green (MG) sorption behaviors with a batch system. The effects of various experimental parameters (e.g. initial pH, sorbent dose, dye concentration, contact time, and temperature etc.) were investigated and the sorption kinetic and thermodynamic characteristics were understood. The MG removal ratios on FS and on CS increased with increasing initial pH and came up to the maximum value beyond pH 6 for FS and pH 8 for CS, respectively. The ratio of sorbed MG kept above 95% for 250 mg/l of MG solution when 2.0 g/l or more of FS was used. The MG removal percentage decreased more on CS than on FS with increasing initial MG concentration. The isothermal data of MG sorbed on FS and on CS followed the Langmuir model. By functionalizing, the sorption capacity (Q(m)) of sawdust for MG was increased from 85.47 to 196.08 mg/g and the sorption equilibrium time of MG was shortened from 23 to 4.5 h. The MG sorption processes on FS and on CS followed the pseudo-second-order rate kinetics. The sorptions of MG on FS and on CS were spontaneous and exothermic processes and lower temperatures were favorable for the sorption processes. (C) 2008 Elsevier Ltd. All rights reserved.