Chemical looping steam reforming for hydrogen production from waste cooking oil was investigated using a packed bed reactor. The steam to carbon ratio of 4 and temperatures between 600 and 700 degrees C yielded the best results of the range of conditions tested. Six cycles at two weighted hourly space velocities (WHSV of 2.64 and 5.28 h(-1)) yielded high (>0.74) and low (<0.2) oil conversion fractions, respectively, representing low and high coking conditions. The WHSV of 2.64 h(-1) yielded product concentrations closest to equilibrium values calculated assuming a fresh rapeseed oil composition. Repeated cycling revealed some output oscillations in reactant conversion and in the extent of Ni-NiO conversion, but did not exhibit deterioration by the 6th cycle. The selectivity of CO, CO(2) and CH(4) were remarkably constant over the performed cycles, resulting in a repeatable syngas composition with H(2) selectivity very close to the optimum. (C) 2010 Elsevier Ltd. All rights reserved.