Although the moderate load (COD of 5000-10,000 mg/L) and biodegradability of the APMP pulping effluent should allow biological treatment, toxic compounds in the effluent can interfere with this type of treatment. Studies were conducted to determine if treatment of the effluent with Aspergillus niger S13 was feasible. Under the optimized conditions (3% inoculum, pH 6, shaking at 160 rpm, 60-72 h, and 30 C), this fungus was able to remove about 97% of the methyl tertiary butyl ether (MTBE) extractives, and 60%, 77% and 43% of the chemical oxygen demand, turbidity and color even without a pre-flocculation step. These results are of practical interest in China because the APMP process has become popular, and efficient and cost-effective effluent treatment technologies are in high demand. (C) 2011 Elsevier Ltd. All rights reserved.