The effects of exposure to ultraviolet (UV) light and ozone, separately and in combination, were investigated with respect to polypropylene (PP) and poly(ethylene terephthalate) (PET) surfaces. Three combinations of UV light and ozone were studied: ozone only, UV light in air (producing ozone), and W light in air (producing ozone) supplemented by additional ozone in the incoming air. The effect of the exposure time of the PP and PET to each treatment was studied. The samples were analyzed by X-ray photoelectron spectroscopy (XPS) to determine the surface composition, and by dynamic contact angle to determine the water wettability. The results showed that the effect of the treament was dependent on the properties of the exposed polymer, with PET being more sensitive to the UV light and PP being more sensitive to the reactive species in the gas. The exposure times studied ranged from 1 to 90 min. By monitoring the oxygen uptake levels, we were able to determine that surface modification occurred within minutes. The possible reactive species and mechanisms are discussed.