| 학회 |
한국공업화학회 |
| 학술대회 |
2009년 봄 (04/15 ~ 04/17, 호텔인터불고(대구)) |
| 권호 |
13권 1호 |
| 발표분야 |
고분자 |
| 제목 |
Study of the flow mark in the precision injection molding of PP composite |
| 초록 |
Flow mark is a kind of surface defect that can arise during the filling stage of the injection molding process. The purpose of this study is to clarify a mechanism of the flow mark that appears on the surface of injection molded PP through the observation of the surface structure. The materials used in this experiment were PP/rubber and PP/talc compounding, which were widely used for automobile part. The flow mark had two different constitutions, such as a luster part and a cloud part, alternately on the both surface. It was obvious that the cloud part was a filler-rich state from the surface analysis of the article. We investigated the surface structure of PP/rubber and PP/talc composites by using IR, SEM, EDS, and OM. |
| 저자 |
신현등1, 임순호1, 조재환2, 임재곤2, 이춘수3
|
| 소속 |
1한국과학기술(연), 2삼성토탈주식회사, 3현대-기아 자동차 |
| 키워드 |
flow mark; injection molding; PP composite
|
| E-Mail |
|
