| 학회 |
한국고분자학회 |
| 학술대회 |
2011년 가을 (10/06 ~ 10/07, 김대중 컨벤션센터) |
| 권호 |
36권 2호 |
| 발표분야 |
유기전자소자용 소재 및 소자(분자전자소재 부문위원회) |
| 제목 |
Large-area Polymer Solar Cells Fabricated by Slot-die Coating Method |
| 초록 |
A Slot-die coating, which uses a continuous solution processing, is one of the promising methods to fabricate the large-area conjugated polymer: fullerene bulk-heterojunction (BHJ) solar cells (PSCs) due to its fast fabrication time, reproducibility and a direct patterning of polymer films. However, during fabricating films by slot-die method, non-uniform evenness of film morphology by a coffee-stain effect from polymer solution droplet and the different evaporation times of a solvent result in the low power conversion efficiency (PCE) in the large area PSCs. In this presentation, we successfully fabricate the large area polymer film(13mmⅩ90mm) based on (P3HT) and (PCBM) with the uniform morphology by controlling the evaporation time through combining the different boiling point, solubility of solvent and slot-die coating speed. As a result, the large area PSCs with 10mmⅩ10mm active area exhibit PCE ＞ 2% under Air Mass 1.5 irradiation (100mW/cm2) |
| 저자 |
홍순일1, 이광희1, 강홍규1, 백형철1, 공재민1, 이종진2
|
| 소속 |
1광주과학기술원, 2RISE |
| 키워드 |
large-area polymer solar cells; slot-die; printing; Coating; OSC
|
| E-Mail |
|
