| 1 |
Morphology and mechanical investigation of microcellular injection molded carbon fiber reinforced polypropylene composite foams
Nobe R, Qiu JH, Kudo M, Zhang GH
Polymer Engineering and Science, 60(7), 1507, 2020 |
| 2 |
Establishing a rapid cooling complex mold design for the quality improvement of microcellular injection molding
Chang YH, Chiu MC, Chen SC, Chang CW, Tseng CY
Polymer Engineering and Science, 60(12), 3072, 2020 |
| 3 |
Investigation on bubble morphological evolution and plastic part surface quality of microcellular injection molding process based on a multiphase-solid coupled heat transfer model
Zhang L, Zhao GQ, Wang GL, Dong GW, Wu H
International Journal of Heat and Mass Transfer, 104, 1246, 2017 |
| 4 |
Experiment and simulation of foaming injection molding of polypropylene/nano-calcium carbonate composites by supercritical carbon dioxide
Xi ZH, Chen J, Liu T, Zhao L, Turng LS
Chinese Journal of Chemical Engineering, 24(1), 180, 2016 |
| 5 |
Water-assisted compounding of cellulose nanocrystals into polyamide 6 for use as a nucleating agent for microcellular foaming
Peng J, Walsh PJ, Sabo RC, Turng LS, Clemons CM
Polymer, 84, 158, 2016 |
| 6 |
A novel method of producing lightweight microcellular injection molded parts with improved ductility and toughness
Sun X, Kharbas H, Peng J, Turng LS
Polymer, 56, 102, 2015 |
| 7 |
The effects of gas counter pressure and mold temperature variation on the surface quality and morphology of the microcellular polystyrene foams
Chen SC, Hsu PS, Hwang SS
Journal of Applied Polymer Science, 127(6), 4769, 2013 |
| 8 |
Effects of silica particle size on the structure and properties of polypropylene/silica composites foams
Hwang SS, Hsu PP
Journal of Industrial and Engineering Chemistry, 19(4), 1377, 2013 |
| 9 |
Artificial neural network-based supercritical fluid dosage control for microcellular injection molding
Sun XF, Turng LS, Dougherty E, Gorton P
Advances in Polymer Technology, 31(1), 7, 2012 |
| 10 |
A novel method for improving the surface quality of microcellular injection molded parts
Lee JJ, Turng LS, Dougherty E, Gorton P
Polymer, 52(6), 1436, 2011 |
