861 - 864 |
다중 음극 전자빔을 이용한 대면적 플라즈마 소스 A Large Area Plasma Source Using Multi-cathode Electron Beam 강양범, 전형탁, 김태영, 정기형, 고동균, 정재국, 노승정 |
865 - 871 |
소결조건이 지르콘 쉘 몰드의 기계적 특성에 미치는 영향 Effect of Sintering condition on Mechanical Properties of Zircon Shell Molds 김재원, 김두현, 서성문, 조창용, 최승주, 김재철 |
872 - 877 |
계면 활성제 첨가한 암모니아수의 소수성 실리콘 웨이퍼와의 반응 세정 효과 The Effect of Surfactants in NH 4 OH on Silicon Surfaces and Particle Removal 박진우, 박진구, 김기섭, 송형수 |
878 - 882 |
분자선증착법으로 성장된 AlGaN 에피층의 표면 형상 분석 Surface Morphology Study of Al, Ga 1? ,N grown by Plasma Induced Molecular Beam Epitaxy 김제원, 최인훈, 박영균, 김용태 |
883 - 889 |
응고조직 및 성분편석에 미치는 내부냉금의 효과 The Effect of Internal Chills on the Solidified Structure and Chemical Segregation 김명한, 조현남, 김정겸, 조형호 |
890 - 895 |
SOI 구조 이용한 결정질 규소 태양전지의 최적설계 Effect of Design Parameters on the Efficiency of the Solar Cells Fabricated Using SOI Structure 이강민, 김영관 |
896 - 899 |
Li 2 ZrO 3 계를 이용한 CO 2 가스 센서 CO 2 Gas Sensor Based on Li 2 ZrO 3 System 박진성, 김시욱, 이은구, 김재열, 이현규, Akbar SA |
900 - 904 |
TiO 2 첨가량에 대한 알루미나 세라믹스의 특성에 관한 연구 A Study on the Properties of Alumina Ceramics as the Amount of TiO 2 Addition 류수착 |
905 - 912 |
분말야금법으로 제조된 Cu-7.5Ni-5Sn 합금의 열처리 조건에 따른 기계적 특성의 변화 Tensile Properties of Powder Metallurgy Processed PM Cu-7.5Ni-5Sn Alloy with Different Heat Treatment Conditions 류재철, 김상식, 한승전, 김창주 |
913 - 918 |
전도성 금속 피복재의 전기전도도에 의한 전자파 차폐효과 분석 Analysis of Electromagnetic Wave Shielding Effectiveness from Electrical Conductivity of Metallized Conductive Sheets 김영식, 최익권, 김성수 |
919 - 925 |
가공열처리에 의한 Alloy 600 재료의 결정립계특성 변화와 입계부식 및 1차측 응력부식균열 거동 Grain Boundary Character Changes and IGA/PWSCC Behavior of Alloy 600 Material by Thermomechanical Treatment 김진, 한정호, 이덕현, 김영식, 노희숙, 김근홍, 김정수 |
926 - 931 |
Sn-3.5Ag/Alloy42 리드프레임 땜납접합의 미세조직과 접합특성에 관한 연구 A Study on the Microstructure and Adhesion Properties of Sn-3.5Ag/Alloy42 Lead-Frame Solder Joint 김시중, 배규식 |
932 - 936 |
O 2 및 H 2 O 를 산화제로 하는 NH 3 / O 2 산화의 성장모델 제안 A Proposal to Growth Model of NH 3 / O 2 Oxidation with species of O 2 and H 2 O 김영조 |
937 - 942 |
Fe-20Cr-1C-1Si 경면처리 합금의 고온 Sliding 마모거동에 미치는 Mn의 영향 The Effect of Mn on the Elevated Temperature Sliding Wear Behavior of Fe-20Cr-1C-1Si Hardfacing Alloy 김근모, 김준기, 양영석, 강성군, 김선진 |
943 - 947 |
La(Mg 1/2 Ti 1/2 )O 3 세라믹스의 구조 및 고주파 유전 특성 연구 Structural and Microwave Dielectric Properties of La(Mg 1/2 Ti 1/2 )O 3 Ceramics 여재현, 백종후, 남산, 이확주, 박현민, 변재동 |