| 4463 - 4484 |
Films of Interstitial Phases - Synthesis and Properties
Andrievski RA |
| 4485 - 4492 |
Microstructure and Solid Particle Erosion of Carbon-Based Materials Used for the Protection of Highly Porous Carbon-Carbon Composite Thermal Insulation
Baxter RI, Rawlings RD |
| 4493 - 4500 |
Mechanical Property Characterization of a Number of Polymers Using Uniaxial Compression and Spherical Tipped Indentation Tests
Kourtesis G, Renwick GM, Fischercripps AC, Swain MV |
| 4501 - 4506 |
Interfacial Characterization of Nicalon SiC Fiber-Reinforced Oxynitride Glass Matrix Composites
Zhang E, Thompson DP, Gao L |
| 4507 - 4512 |
Nanostructured and Near Defect-Free Ceramics by Low-Temperature Pressureless Sintering of Nanosized Y-TZP Powders
Duran P, Villegas M, Capel F, Fernandez JF, Moure C |
| 4513 - 4521 |
Preparation and Characterization of Alumina-Iron Cermets by Hot-Pressing of Nanocomposite Powders
Guichard JL, Tillement O, Mocellin A |
| 4523 - 4531 |
Structure-Property Relationships in Polyethylene Blends - The Effect of Morphology on Electrical Breakdown Strength
Hosier IL, Vaughan AS, Swingler SG |
| 4533 - 4540 |
Characterization of the Intermetallic G-Phase in an AISI-329 Duplex Stainless-Steel
Mateo A, Llanes L, Anglada M, Redjaimia A, Metauer G |
| 4541 - 4547 |
Microwave-Assisted Oxygenation of Melt-Processed Bulk YBa2Cu3O7-Delta Ceramics
Rowley AT, Wroe R, Vazqueznavarro D, Lo W, Cardwell DA |
| 4549 - 4557 |
Improving the Fracture-Toughness of MgO-Al2O3-SiO2 Glass/Molybdenum Composites by the Microdispersion of Flaky Molybdenum Particles
Waku Y, Suzuki M, Oda Y, Kohtoku Y |
| 4559 - 4573 |
Chemical-Reactivity of Aluminum with Boron-Carbide
Viala JC, Bouix J, Gonzalez G, Esnouf C |
| 4575 - 4583 |
Microstructural Characterization of Surface-Layers Formed on a Low-Alloy Steel During Erosion - Oxidation in a Fluidized-Bed
Rogers PM, Hutchings IM, Little JA, Kara F |
| 4585 - 4589 |
The Relationship Between Crystal Misorientation and Conductive Mode Contrast of Grain-Boundaries in Additive-Free Zinc-Oxide
Russell JD, Halls DC, Leach C |
| 4591 - 4594 |
Comparison of Transmission Electron-Microscopy and Optical Microstructures in Al-1-Percent Mg After Plane-Strain Compression
Baxter GJ, Whiteman JA, Sellars CM |
| 4595 - 4602 |
The Interphase and Interface Microstructure and Chemistry of Isothermal/Isobaric Chemical-Vapor Infiltration SiC/BN/SiC Composites - TEM and Electron-Energy-Loss Studies
Leparoux M, Vandenbulcke L, Serin V, Sevely J |
| 4603 - 4611 |
Effect of Copper Addition on the Beta-Phase Formation Rate in Fesi2 Thermoelectric-Materials
Yamauchi I, Suganuma A, Okamoto T, Ohnaka I |
| 4613 - 4617 |
The Falling Weight Impact Properties of Maleic-Anhydride Compatibilized Polypropylene-Polyamide Blends
Tjong SC |
| 4619 - 4622 |
Electronic Paramagnetic-Resonance Investigation of the Evolution of Defects in Zinc-Oxide During Tribophysical Activation
Kakazey NG, Sreckovic TV, Ristic MM |
| 4623 - 4626 |
Annealing Dependence of the Superconductivity of Pb0.65Sr2.35Y0.5Ca0.5Cu2Oy
Jin H, Ruan KQ, Wang LB, Qiu YM, Wang CY, Zhou VQ, Cui XD, Cao LZ, Chen ZJ, Zhang YH, Zhou L |
| 4627 - 4632 |
Preparation of Hexa-Aluminate Catalyst Thick-Films on Alpha-SiC Substrate for High-Temperature Application
Inoue H, Sekizawa K, Eguchi K, Arai H |
| 4633 - 4639 |
Contribution of H-1 Combined Rotation and Multipulse Spectroscopy Nuclear-Magnetic-Resonance to the Study of Tricalcium Silicate Hydration
Bresson B, Zanni H, Masse S, Noik C |
| 4641 - 4643 |
Direct Observation of Resistive Barriers in a BaTiO3 Based Thermistor
Leach C, Russell JD, Wood GI |
| 4645 - 4654 |
The Complex Characteristics of Crystallization of the Fe75Si15B10 Glassy Ribbon
Illekova E, Matko I, Duhaj P, Kuhnast FA |
| 4655 - 4660 |
Preparation and Properties of Glass-Ceramic Materials Obtained by Recycling Goethite Industrial-Waste
Pelino M, Cantalini C, Rincon JM |
| 4661 - 4671 |
Preparation and Properties of Pb0.99Nb0.02(Zr0.52Ti0.48)(0.98)O-3 by a New Sol-Gel Technique
Yang XM, Chaki TK |
| 4673 - 4677 |
Effect of Notch Geometry on Short Fatigue-Crack Growth in 8090-Al-Li Alloy
Shan ZH, Wang ZG, Zhang Y |
| 4679 - 4686 |
Ask-Edge EXAFS Study of the Ternary-System Sb2S3-As2S3-Tl2S
Durand JM, Olivierfourcade J, Jumas JC, Womes M, Parent P |
| 4687 - 4692 |
Acid and Base Effects on the Morphology of Composites Formed from Microemulsion Polymerization and Sol-Gel Processing
Mukkamala R, Cheung HM |
| 4693 - 4699 |
Growth of Diamond Films on SiC, WC and Cubic BN Substrates
Echigoya J, Enoki H, Kaminishi S |
| 4701 - 4709 |
3-Dimensional Shape of the Y2BaCuO5 Pattern in Melt-Textured Y-Ba-Cu-O Oxide
Kim CJ, Kibaikkim, Park HW, Kuk IH, Hong GW |
| 4711 - 4713 |
The Characteristics of Combustion in a Centrifugal-Thermite Process
Liu M, Sheng Y, Wei YP, Lai H |
| 4715 - 4718 |
Particle-Size and Morphology of Hydrothermally Processed Mnzn Ferrites Observed by Atomic-Force Microscopy
Dias A, Buono VT, Vilela JM, Andrade MS, Lima TM |
| 4719 - 4722 |
Degradation of Al2O3-SiC-Al Composites Prepared by the Oxidative Growth of Al-Alloys into SiC Particulate
Kumar S, Jayaram V, Mani TV, Warrier KG |
| 4723 - 4729 |
Microstructure of TiNi Shape-Memory Alloy Synthesized by Explosive Shock-Wave Compression of Ti-Ni Powder Mixture
Han XD, Zou WH, Wang RH, Jin S, Zhang Z, Li TC, Yang DH |
| 4731 - 4736 |
Limitations of Pore-Stress Concentrations on the Mechanical-Properties of Porous Materials
Rice RW |
