1 - 2 |
Proceedings of the 4th International Conference on Microelectronics and Plasma Technology (ICMAP 2012), Jeju, Korea Preface [Anonymous] |
3 - 8 |
Characteristics of sputtered ZnO films for buffer layer in inverted organic solar cells Lee JH, Hong B, Park YS |
9 - 12 |
Method for measurement of transferred power to plasma in inductive discharges Hwang HJ, Kim YC, Chung CW |
13 - 16 |
Experimental investigation of plasma recovery during the pulse-off time in plasma source ion implantation Chung KJ, Jung B, Choe JM, Kim GH, Hwang YS |
17 - 21 |
Double transparent conducting layers for Si photovoltaics Yun JH, Kim J, Park YC, Moon SJ, Anderson WA |
22 - 27 |
Effect of substrate temperatures on evaporated In2S3 thin film buffer layers for Cu(In, Ga)Se-2 solar cells Zhong ZY, Cho ES, Kwon SJ |
28 - 31 |
Numerical analysis of free-burning argon arcs based on the local thermodynamic equilibrium model at various electrical currents Kim YJ, Lee JC |
32 - 37 |
Oxygen effect of transparent conducting amorphous Indium Zinc Tin Oxide films on Polyimide substrate for flexible electrode Ko YD, Lee CH, Moon DK, Kim YS |
38 - 42 |
Mode transition of power dissipation and plasma parameters in an asymmetric capacitive discharge Lee SJ, Lee HC, Bang JY, Oh SJ, Chung CW |
43 - 46 |
Influence of Al2O3 reflective layer under phosphor layer on luminance and luminous efficiency characteristics in alternating-current plasma display panel Park CS, Tae HS, Jung EY |
47 - 51 |
Characteristics of aluminum-doped zinc oxide films with oxygen plasma treatment for solar cell applications Park YS, Seo M, Yi J, Lim D, Lee J |
52 - 56 |
Measurements of electron energy probability functions in helicon discharge by laser Thomson scattering Seo BH, You SJ, Kim JH, Seong DJ, Shin YH, Chang HY |
57 - 62 |
Development of highly flexible and ultra-low permeation rate thin-film barrier structure for organic electronics Kim N, Graham S |
63 - 67 |
Al2O3/Ag/Al2O3 multilayer thin film passivation prepared by plasma damage-free linear facing target sputtering for organic light emitting diodes Jeong JA, Kim HK |
68 - 71 |
Spray deposition of LiMn2O4 nanoparticle-decorated multiwalled carbon nanotube films as cathode material for lithium-ion batteries Hong HP, Kim MS, Lee YH, Yu JS, Lee CJ, Min NK |
72 - 76 |
Analysis of the crystalline characteristics of nc-Si: H thin film using a hyperthermal neutral beam generated by an inclined slot-excited antenna Park JB, Kim YW, Kim DC, Kim J, Hong SP, Yoo SJ, Oh KS |
77 - 80 |
Deposition and surface treatment of Ag-embedded indium tin oxide by plasma processing Kim JY, Kim JK, Kim JY, Kwon MK, Yoon JS, Lee JM |
81 - 85 |
Optical wave microphone measurements of laser ablation of copper in supercritical carbon dioxide Mitsugi F, Ikegami T, Nakamiya T, Sonoda Y |
86 - 90 |
Structural and electrical properties of radio frequency magnetron sputtered Cu(InxGa1-x)Se-2 thin films with additional post-heat treatment Jung SH, Fan R, Lee WI, Chung CW |
91 - 94 |
Multi-layer TiO2 films prepared by aerosol deposition method for dye-sensitized solar cells Cho SH, Yoon YJ |
95 - 98 |
Indium tin oxide-rod/single walled carbon nanotube based transparent electrodes for ultraviolet light-emitting diodes Yun MJ, Kim HD, Kim KH, Sung HJ, Park SY, An HM, Kim TG |
99 - 105 |
The effects of enhancing the surface energy of a polystyrene plate by air atmospheric pressure plasma jet on early attachment of fibroblast under moving incubation Lee JH, Kwon JS, Kim YH, Choi EH, Kim KM, Kim KN |
106 - 110 |
Fabrication of enhancement-mode AlGaN/GaN high electron mobility transistors using double plasma treatment Lim JW, Ahn HK, Kim SI, Kang DM, Lee JM, Min BG, Lee SH, Yoon HS, Ju CW, Kim H, Mun JK, Nam ES, Park HM |
111 - 115 |
Nanotextured and polytetrafluoroethylene-coated superhydrophobic surface Lee D, Seo SB, Kim DY, Kim HM, Cho C, Lee J, Lim S, Kim J, Lee B, Kim B |
116 - 119 |
Enhancement of the power conversion efficiency for organic photovoltaic cells with a Liq/bathocuproine electron transport bilayer Xu K, Kim DH, Lee SH, Kim TW |
120 - 124 |
Effect of surface treatment on the high-speed drop reliability of Pb-free solder interconnect Kim JW, Lee HJ, Jung SB |
125 - 131 |
Effects of the physical parameters of a microwave plasma jet on the inactivation of fungal spores Na YH, Park G, Choi EH, Uhm HS |
132 - 136 |
Simulation of spatial characteristics of very high frequency hydrogen plasma produced by a balanced power feeding Ogiwara K, Chen WT, Uchino K, Kawai Y |
137 - 140 |
Indication of room temperature ferromagnetism in highly transparent and conductive Ga-doped SnO2 thin films Anwar MS, Ahmed F, Heo SN, Park KY, Koo BH |
141 - 145 |
Self-forming barrier characteristics of Cu-V and Cu-Mn films for Cu interconnects Park JH, Moon DY, Han DS, Kang YJ, Shin SR, Park JW |
146 - 150 |
Inductively coupled plasma reactive ion etching of magnetic tunnel junction stacks using H2O/CH4 mixture Lee TY, Lee IH, Chung CW |
151 - 155 |
The effects of UV radiation on SiC(O)N/SiOC(-H) thin films grown on Si substrates using plasma-enhanced atomic layer deposition Navamathavan R, Kim CY, Lee HJ, Yu Y, Choi CK |
156 - 162 |
Selenization annealing effect of DC-sputtered metallic precursors using the rapid thermal process for Cu(In,Ga)Se-2 thin film solar cells Li ZH, Cho ES, Kwon SJ |
163 - 167 |
Impact of water corrosion on nanoscale conductance on aluminum doped zinc oxide Kim JH, Lee H, Choi S, Bae KH, Park JY |
168 - 172 |
Facile growth of ZnO nanorod arrays by a microwave-assisted solution method for oxygen gas sensing Ahmed F, Arshi N, Anwar MS, Danish R, Koo BH |
173 - 177 |
Enhancement of flexural stress and reduction of surface roughness through changes in gas concentrations during high-speed chemical dry thinning of silicon wafers Kim IJ, Lee NE |
178 - 180 |
Effect of selenization on sprayed Cu2ZnSnSe4 thin film solar cell Kim S, Kim J |
181 - 187 |
Time-dependent growth of TiO2 nanotubes from a magnetron sputtered Ti thin film Uhm SH, Song DH, Kwon JS, Im SY, Han JG, Kim KN |
188 - 192 |
Evolution of gold thin films to nanoparticles using plasma ion bombardment and their use as a catalyst for carbon nanotube growth Lee SH, Kwak EH, Kim HS, Lee SW, Jeong GH |
193 - 197 |
Scale-up approach for industrial plasma enhanced chemical vapor deposition processes and SiOx thin film technology Jin SB, Lee JS, Choi YS, Choi IS, Han JG, Hori M |
198 - 201 |
Optical and electrical properties of V2O5 nanorod films grown using an electron beam Kang M, Chu M, Kim SW, Ryu JW |
202 - 206 |
Field-emission performance and structural change mechanism of multiwalled carbon nanotubes by oxygen plasma treatment Kim JY, Jeong T, Baik CW, Park SH, Han I, Kim GH, Yu S |
207 - 211 |
Synthesis, structural and optical properties of pure and rare-earth ion doped TiO2 nanowire arrays by a facile hydrothermal technique Bandi VR, Raghavan CM, Grandhe BK, Kim SS, Jang K, Shin DS, Yi SS, Jeong JH |
212 - 215 |
Performances of amorphous silicon and silicon germanium semi-transparent solar cells Lim JW, Lee SH, Lee DJ, Lee YJ, Yun SJ |
216 - 221 |
Stress control of sputtered W film using W/WN multilayer Han DH, Bae JY, Park SJ, Jung WK, Kim HJ, Won J |
222 - 224 |
Enhanced light extraction from Y2O3:Eu3+ phosphor films via vacuum nano-imprint lithography using spin-on dielectric materials Lee K, Ko KY, Ahn J |
225 - 229 |
Effect of thickness and substrate temperature on the properties of transparent Ti-doped In2O3 films grown by direct current magnetron sputtering Kim DJ, Kim BS, Kim HK |
230 - 234 |
CO sensitivity of La2O3-doped SnO2 thick film gas sensor Choi JY, Oh TS |
235 - 240 |
Surface modification of biphasic calcium phosphate scaffolds by non-thermal atmospheric pressure nitrogen and air plasma treatment for improving osteoblast attachment and proliferation Choi YR, Kwon JS, Song DH, Choi EH, Lee YK, Kim KN, Kim KM |
241 - 245 |
Enhanced gas sensing properties of branched ZnO nanowires An S, Park S, Ko H, Jin C, Lee WI, Lee C |
246 - 249 |
Electron beam curing of acrylated epoxy resins for anisotropic conductive film application Shin TG, Lee I, Lee J, Hwang J, Chung H, Shin K, Seo YS, Kim J |
250 - 255 |
A cutoff probe for the measurement of high density plasma You KH, You SJ, Kim DW, Na BK, Seo BH, Kim JH, Shin YH, Seong DJ, Chang HY |
256 - 262 |
Optimization of intrinsic hydrogenated amorphous silicon deposited by very high-frequency plasma-enhanced chemical vapor deposition using the relationship between Urbach energy and silane depletion fraction for solar cell application Shin C, Iftiquar SM, Park J, Kim Y, Baek S, Jang J, Kim M, Jung J, Lee Y, Kim S, Yi J |
263 - 266 |
Drain bias effect on the instability of amorphous indium gallium zinc oxide thin film transistor Seo SB, Park HS, Jeon JH, Choe HH, Seo JH, Yang S, Park SHK |
267 - 271 |
Performance and direct-coupled FET logic applications of InAlAs/InGaAs co-integrated field-effect transistors by 2-D simulation Tsai JH, Huang CH, Ou-Yang JJ, Chao YT, Jhou JC, Wu YR |
272 - 275 |
Time-resolved and temperature-dependent photoluminescence studies on CdTe/ZnTe quantum dots with different ZnTe capping layer thicknesses Lee HS |
276 - 279 |
Analytic representation of the dielectric functions of InAsxSb1-x alloys in the parametric model Hwang SY, Kim TJ, Byun JS, Barange NS, Diware MS, Kim YD, Aspnes DE, Yoon JJ, Song JD |
280 - 284 |
Plasma density measurement with ring-type cutoff probe Kim DW, You SJ, Na BK, Kim JH, Shin YH, Chang HY, Oh WY |
285 - 288 |
Cu doping effects on the electronic and optical properties of Cu-doped ZnO thin films fabricated by radio frequency sputtering Sung NE, Kang SW, Shin HJ, Lee HK, Lee IJ |
289 - 292 |
The effect of the driving frequency on the optimum hole diameter for efficient multi-hole electrode RF capacitively coupled plasma Lee H, Kim E, Lee Y, Chang H |
293 - 298 |
Research of non-uniformity in 450 mm multi-electrode capacitive coupled plasma Park GJ, Lee YS, Seo SH, Chung CW, Chang HY |