Mesoporous V2O5/TiO2 particles with a spherical shape were prepared via spray pyrolysis, using P123 as a structure directing agent, and applied to the catalytic oxidation of 1, 2- dichlorobenzene (DCB). The texture properties of the prepared V2O5/TiO2 particles were monitored by changing the P123/Ti molar ratio from 0.03 to 0.07 and the vanadia content from 3 to 7 wt%. All the prepared samples had mesopores, but without any pore ordering. The sample prepared with a P123/Ti = 0.05 (molar ratio) had the largest surface area (142 m2/g) and smallest pore size (6.6 nm). The quantity of vanadia loading affected the texture properties as well as the crystallographic form of the V2O5/TiO2 particles. The major crystal phases of mesoporous V2O5/TiO2 particles were anatase, but 7-30% were formed in the rutile phase, which depended on the quantity of vanadia loading. However, the catalytic activity of V2O5/TiO2 particles progressively increased with increasing quantity of vanadia loading. With 7 wt% V2O5/TiO2 particles, 94% decomposition of 1, 2-DCB was achieved at 400℃ . The mesoporous V2O5/TiO2 particles prepared via spray pyrolysis showed higher catalytic activity compared with that prepared via the conventional impregnation method, which was due to the high dispersion of vanadia on the surface of pores. From the results obtained, the mesoporous V2O5/TiO2 particles prepared via spray pyrolysis were confirmed to have excellent activity for the oxidation of 1, 2-DCB, particularly at temperatures lower than 350℃ .